I ordered a basic wood carver tool set today. I have been doing some interesting wood carving (vaporizing) with a high speed air powered rotary hand piece. I enjoy the creativity of carving. I just remove everything that doesn’t look like what I want. Ha!
Actually there is a bit more to it than that but it is the main idea. I haven’t done serious knife and wood carving since Boy Scouts. I did get a merit badge in carving about 45 years ago. I have no real carving knives or tools (gouges) at this point in my life so I ordered a beginner’s set on the Internet from Little Shavers Woodcarving Supply in Seattle, Washington.
There are a lot of suppliers available, but this is the place where I found a reasonably complete set of beginners’ tools (and accessories) at a very reasonable price. Good information too. I figure I can always upgrade to more pricy tools if I get the bug and need better tools to do more. I like the fact that this fellow Rick is very youth oriented.
Some of the carving I want to do is not suitable using the high speed hand piece. The dust produced by the rotary tool is also not healthy. Cutting real chips on the other hand is much more user/producer friendly. They can still be a mess but they are not filling up my sinuses and maybe lungs with wood fibers.
Another benefit I want to test is to see if the carving will help or perhaps hinder the strength problems I have in my hands. My CMT damage is now in my hands and arms as well as my legs but not as bad. I hope working with my hands will keep the wires (nerves) connected. The worst that usually happens is cramping.
Watch for some show and tell when I kick this into gear.